Brake System (Complete): Remove & Replace
WARNING: This page is about the Compass High Altitude, 2.0L Eng VIN A, which is a different variant/trim than selected.
Includes: Replace Calipers and/or Wheel Cylinders, Brake Shoes and/or Pads. Clean, lube and/or replace Brake Hardware as necessary. Inspect Master Cylinder, all Hoses and bleed Brake System. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Wheels,w/Front and Rear Disc | 2.6 | B | ||
| All Wheels,w/Front Disc and Rear Drum | 3.0 | B | ||
| Combination Procedure: AXLE OR WHEEL BEARING: Replace: | ||||
| FWD, Rear,One Side | 0.3 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | 0.6 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: DOES NOT include alignment (unless noted otherwise). | ||||
| Front,One Side | Includes: R&I Steering Knuckle. DOES NOT include wheel alignment. | 1.0 | B | |