LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2016 >> Compass Sport SE, 2.0L Eng VIN A >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Rear Driveline Module) >> Seal, Input Flange >> Removal >> Removal

Seal, Input Flange: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Electric Clutch At Rear Axle
GC0083879Courtesy of CHRYSLER GROUP, LLC
  1. Raise the vehicle on a hoist.
  2. Remove the propeller shaft. Refer to REMOVAL .
  3. Unplug the electrical connector (3) at the Electronically Controlled Clutch (ECC).
  4. Disconnect ECC breather hose.
  5. Remove the ECC to RDA mounting bolts.
  6. Separate and lower ECC.
  7. Remove all old gasket material on the mating surfaces of the ECC and RDA. Remove wave washer
  8. Remove wave washer.
    Fig 2: Removing Input Flange Seal
    GC0083886Courtesy of CHRYSLER GROUP, LLC
  9. Remove the input flange seal.
scientia non olet · About LEMON Manuals