LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2016 >> Compass Sport SE, 2.0L Eng VIN A >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.4L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Left >> Installation >> Installation

Insulator, Engine Mount, Left: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Left Engine Mount Assembly
GC0084959Courtesy of CHRYSLER GROUP, LLC
  1. Position mount (2) in place.
  2. Install left mount to frame rail bolts (1) and torque to 75 N.m (55 ft. lbs.).
  3. Install mount through bolt (3) and torque to 100 N.m (74 ft.lbs.).
  4. Remove jack.
    Fig 2: Air Cleaner Body, Air Inlet Tube & Make-Up Air Hose
    GC0145278Courtesy of CHRYSLER GROUP, LLC
  5. Push down on the air cleaner body (1) to engage the pins into the grommets.
  6. Install the support bracket bolt to the strut tower and tighten to 10 N.m (89 in. lbs.).
  7. Install the air inlet tube (2) to the air cleaner body (1).
  8. Connect the make-up air hose (3) to the air cleaner body.
    Fig 3: Electrical Connectors, PCM, Three Mounting Bolts & Ground Wire
    GC0145274Courtesy of CHRYSLER GROUP, LLC
  9. Install the mounting bolt (3) with ground wire (1) and tighten to 12 N.m (106 in. lbs.).
  10. Connect and lock the electrical connectors (2).
    Fig 4: Retainers, Fresh Air Inlet Duct & Air Cleaner Body
    GC0145275Courtesy of CHRYSLER GROUP, LLC
  11. Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
  12. Install the fresh air inlet duct (3) on the air cleaner body (1) and lock the retainers (2).
scientia non olet · About LEMON Manuals