Seal, Crankshaft Oil, Rear: Removal: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove transmission and flexplate (1). Refer to FLEXPLATE, REMOVAL .
- Insert a 3/16 flat bladed screwdriver (7) between the dust lip (8) and the metal case (4) of the crankshaft seal (1). Angle the screwdriver through the dust lip against metal case of the seal. Pry out seal.CAUTION:
Do not permit the screwdriver blade to contact crankshaft seal surface. Contact of the screwdriver blade against crankshaft edge (chamfer) is permitted.
- Check to make sure the seals garter spring is not on the crankshaft.
