Door Ajar Indicator

The ajar indicators give an indication to the vehicle operator that one or more of the passenger compartment doors or the swing gate may be open or not completely latched. These indicators are controlled by the CCN logic circuit based upon programming and electronic ajar switch status  messages from the TIPM over the CAN data bus.

The ajar indicator function of the odometer VFD unit is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when the instrument cluster receives a battery current input on the fused B(+) circuit. Therefore, the VFD ajar indications can occur regardless of the ignition switch position. The CCN will turn On the ajar indicator for the following reasons:

• Ajar Switch Message Input  - Each time the CCN receives a door or swing gate ajar switch status message indicating that a door, the swing gate or any combination of these is open or not completely latched with the ignition switch in any position, the appropriate ajar textual message will be illuminated. If the cluster detects a vehicle speed input greater than zero (kilometers or miles-per-hour) while the ignition switch is in the ON or START positions, the ajar indication will be accompanied by a single chime tone. When the ignition switch is in any position except ON or START, any and all ajar indications will time out after about five minutes.

The TIPM continually monitors the door and swing gate ajar switches to determine the status of the doors and swing gate. The TIPM then sends the proper ajar switch status messages to the CCN. The door and swing gate ajar switches and their circuits may be diagnosed using conventional diagnostic tools and methods. Refer to the appropriate wiring information.