Diagnostic Test

VERIFY ACTIVE DTC
NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. With the scan tool, read the ORC DTCs.
  Does the scan tool display active B1B54-1ST ROW PASSENGER SEAT BELT SENSOR CIRCUIT LOW DTC?
  
  Yes
  - Go To 2
  No
  - Perform the AIRBAG SYSTEM INTERMITTENT TEST. Refer to AIRBAG SYSTEM INTERMITTENT TEST .
PASSENGER SEAT BELT SWITCH SIGNAL CIRCUIT SHORTED TO GROUND
WARNING:
Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
1. Disconnect the Passenger Seat Belt Switch harness connector.
2. Disconnect the ORC harness connectors.
  NOTE:
  Check harness connectors - Clean and repair as necessary.
3. Connect the SRS Load Tool Adapter (special tool #8443-25, 56 Way ACM Adapter) to the ORC harness connectors.
4. Measure the resistance of the (R58) Passenger Seat Belt Switch Signal circuit between the appropriate terminal of the SRS Load Tool Adapter and ground.
  Is the resistance below 10.0 Ohms?
  
  Yes
  - Repair or replace the (R58) Passenger Seat Belt Switch Signal circuit for a short to ground.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - AIRBAG SYSTEM VERIFICATION TEST .
  No
  - Go To 3
PASSENGER SEAT BELT SWITCH SIGNAL CIRCUIT SHORTED TO GROUND
1. Replace the Passenger Seat Belt Switch.
2. Disconnect the SRS Load Tool Adapter (special tool #8443-25, 56 Way ACM Adapter).
3. Reconnect the ORC harness connectors.
  WARNING:
  Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
4. With the scan tool, read all active ORC DTCs.
  Does the scan tool display active B1B54-1ST ROW PASSENGER SEAT BELT SENSOR CIRCUIT LOW DTC?
  
  Yes
  
  WARNING:
  Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  
  WARNING:
  If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
  - Replace the ORC in accordance with the Service Information.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - AIRBAG SYSTEM VERIFICATION TEST .
  No
  - The repair is complete.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - AIRBAG SYSTEM VERIFICATION TEST .