Diagnostic Test

DETERMINE ACTIVE OR STORED FAULT CODE
NOTE:
If the scan tool shows this DTC has a Stored history of setting then the right side impact sensor is to be replaced.

NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. With the scan tool, read the active ORC DTCs.
  Is the DTC active or shows a setting history in stored?
  
  Yes
  
  WARNING:
  Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  
  NOTE:
  Inspect the related wiring harness related to the door pressure sensor for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
  - Go To 2
  No.
  - Perform the AIRBAG SYSTEM INTERMITTENT TEST. Refer to AIRBAG SYSTEM INTERMITTENT TEST .
VERIFY OPERATION OF THE RIGHT SIDE IMPACT PRESSURE SENSOR
WARNING:
Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
1. Replace the Right Side Front Door Impact Pressure Sensor in accordance with the Service Information. (Refer to 10 - Restraints/SENSOR, Impact/Removal and Installation). REMOVAL
2. Reconnect the vehicle wire harness to the sensor.
3. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.
  WARNING:
  Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
4. Use the scan tool and erase the stored codes in all airbag system modules.
5. Turn the Ignition Off, and wait 15 seconds before turning the Ignition On.
6. Wait one minute, and read active codes.
  Did the active DTC return?
  
  Yes
  - Go To 3
  No
  - Repair is complete.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - AIRBAG SYSTEM VERIFICATION TEST .
REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING:
Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING:
If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.

If all possible causes have been done, view repair.

Repair
- Replace the ORC in accordance with Service Information.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - AIRBAG SYSTEM VERIFICATION TEST .