Lamp - Domestic
Courtesy of CHRYSLER GROUP, LLC
Courtesy of CHRYSLER GROUP, LLC
- Disconnect and isolate the battery negative cable.
- Open the liftgate to access and remove the two push pin fasteners (5) that secure the rear lamp unit (4) to the side trough of the liftgate opening.
- Pull the outboard side of the rear lamp unit rearward far enough to unsnap the two ball studs on the outboard side of the lamp housing from the two plastic grommets (3) in the quarter outer panel (2).
- Pull the lamp away from the vehicle far enough to access and disconnect the unibody wire harness connectors (1, 6 and 8) from the bulb socket connector receptacles and the pigtail wire connector on the back of the lamp housing.
- Remove the lamp from the lamp opening of the quarter outer panel.