Differential And Ring Gear: Assembly: Fwd
WARNING: This page is about a different variant/trim than selected.
Clean the differential in suitable solvent and inspect components for damage or debris. Dry the components with regulated 344 kPa (50 psi) shop air. Do not free spin the bearings with shop air.
- Install the side gear thrush washer (1) into the differential (2).
- Install the side gear (1) into the differential case (2).
- Install the conical washers (1) and pinion gears (2) into the differential case.
- Slide the differential link shaft (1) into the differential case (3)
- Install the pin (1) to hold the differential link shaft (3) into the differential case (2).
- Place the side gear (2) into the differential (3).
- Place the side gear thrust washer (1) onto the side gear (2).
- Place the ring gear half (1) of the case onto the differential (2).
- Install the screws (1) to hold the differential case halves (2) together. Refer to SPECIFICATIONS .
- Place the ring gear (1) in position on the differential (3).
- Install the bolts (2) to hold the ring gear (3) to the differential. Refer to SPECIFICATIONS .
- Place the differential in position in the transaxle housing.
- Assemble the transaxle. Refer to ASSEMBLY .
- Install the transaxle in the vehicle. Refer to INSTALLATION .









