Pump, Fluid: Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

NOTE:

The fluid pump components must be thoroughly cleaned before assembly.

NOTE:

Inspect fluid pump components for damage or excessive wear before assembly. If damage is evident, replace the fluid pump.

Fig 1: Fluid Pump Housing & Rotor Assembly

Courtesy of CHRYSLER GROUP, LLC

Insert the gerotor assembly (2-3) into the fluid pump housing (1). Center the rotor to the center of the pump housing bushing.

Fig 2: Fluid Pump & Fluid Pump Cover
Courtesy of CHRYSLER GROUP, LLC
Place the fluid pump cover (1) over the fluid pump housing (2).

Fig 3: Fluid Pump Cover
Courtesy of CHRYSLER GROUP, LLC
Install screws to hold fluid pump cover (1) to the fluid pump housing. Refer to SPECIFICATIONS .
Install the 2-6 brake piston from the fluid pump housing. Refer to BRAKE AND PISTON, 2-6, INSTALLATION .
Assemble the transaxle. Refer to DISASSEMBLY .
Install the transaxle in the vehicle. Refer to INSTALLATION .
Fill the transaxle with specified fluid. Refer to FLUID, STANDARD PROCEDURES .