Shifter, Floor Console: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL .

Fig 1: PRND Wire Connector & Shifter Assembly
Courtesy of CHRYSLER GROUP, LLC
Disconnect the gear shifter lever wire harness connector from the shifter assembly.

Fig 2: Shifter Housing, Cable & Cable End
Courtesy of CHRYSLER GROUP, LLC
Disconnect the Brake Ignition Transmission Shifter Interlock (BITSI) cable end (3) from the shifter.
Remove the BITSI cable (2) from the shifter housing (1).

Fig 3: Shifter Assembly & Gear Shift Cable End
Courtesy of CHRYSLER GROUP, LLC
Pry the gear shift cable end (2) from the pin under the shifter assembly (3).

Fig 4: Gear Shifter Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Remove the bolts (1) holding the gear shifter to the floor.
Remove the gear shifter from the vehicle.