Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, record and erase DTCs
2. Operate the Driver Door Lock Switch in all positions several times.
3. Cycle the ignition from on to off.
4. Turn the ignition on.
5. With the scan tool, read DTCs.
  Does the scan tool display B1801-DRIVER DOOR LOCK/UNLOCK SWITCH CIRCUIT LOW?
  
  Yes
  - Go To 2
  No
  - The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
DOOR LOCK SWITCH SHORTED

Fig 1: Checking Door Lock Switch For A Short
Courtesy of CHRYSLER GROUP, LLC
1. With the scan tool, erase DTCs.
2. Disconnect the Driver Window/Door Lock Switch C2 connector.
3. With the scan tool, read DTCs.
  Did the DTC return?
  
  No
  - Replace the Driver Window/Door Lock Switch in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
  Yes
  - Go To 3
(P697) DOOR LOCK SWITCH MUX CIRCUIT SHORT TO GROUND

Fig 2: Checking Driver Door Lock Switch MUX Circuit For A Short To Ground
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Disconnect the Cluster C2 connector.
3. Measure the resistance between ground and the (P697) Door Lock Switch Mux circuit.
  Is the resistance below 10k ohms?
  
  Yes
  - Repair the (P697) Door Lock Switch Mux circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .
  No
  - Replace the Instrument Cluster in accordance with Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE - BODY VERIFICATION TEST .