Cylinder, Clutch Master, LHD: Installation: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Brake fluid will damage painted surfaces. If brake fluid is spilled on any painted surfaces, wash it off immediately with water.
Courtesy of CHRYSLER GROUP, LLC- Connect clutch master cylinder supply hose (2) to clutch master cylinder (4).
- Verify that brake master cylinder reservoir (1) is full and cap is off.
- Position clutch master cylinder body vertically, with pushrod pointing down, for about ten seconds to purge air trapped from end of cylinder.
- Install clutch master cylinder body (4) to dash panel and 1/4 turn to secure.
- Insert hydraulic tube (6) into master cylinder pressure line connector (5) and install retaining clip.
- Connect clutch master cylinder rod (3) to clutch pedal pin. An audible "click" should be heard.
- Install lower instrument panel bezel.
- Connect negative battery cable.
- Install air cleaner assembly. For 2.0L, refer to BODY, AIR CLEANER, INSTALLATION . For 2.4L, refer to BODY, AIR CLEANER, INSTALLATION .
- Verify that brake master cylinder reservoir (1) is full. Top off with DOT 3 brake fluid if necessary.
- Bleed clutch system. Refer to STANDARD PROCEDURE .
- Actuate clutch pedal a minimum of fifteen times to allow any air ingested into the system to vent to the master cylinder reservoir. If residual air becomes trapped in the system, it is necessary to bleed the clutch hydraulic system. Refer to STANDARD PROCEDURE .
- Verify proper clutch release system operation.