Section 8 (Right Rear Half Shaft): Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Driveline Module Drain Plug

Courtesy of CHRYSLER GROUP, LLC

Raise vehicle on a hoist.
Remove the rear tires.
Drain the fluid from the rear driveline module.
Remove the rear propeller shaft. Refer to REMOVAL .

Fig 2: Right Sway Bar Nut
Courtesy of CHRYSLER GROUP, LLC
Remove right side sway bar nut (1) (if equipped).

Fig 3: Left Side Sway Bar Nut
Courtesy of CHRYSLER GROUP, LLC
Remove left side sway bar nut (1) (if equipped).

Fig 4: Sway Bar
Courtesy of CHRYSLER GROUP, LLC
Roll sway bar (2) (if equipped) down and out of the way.

Fig 5: Left Side Stay Bar
Courtesy of CHRYSLER GROUP, LLC
Remove the left side stay bracket bolts (1).

Fig 6: Right Stay Bar
Courtesy of CHRYSLER GROUP, LLC
Remove the right side stay bracket bolts (1).
Remove the exhaust system up to the catalytic converter. Refer to MUFFLER, EXHAUST, REMOVAL .
Support the rear driveline module with a transmission jack.

Fig 7: Rear Bolt At Axle
Courtesy of CHRYSLER GROUP, LLC
Remove the rear bolt (1) at the driveline module.

Fig 8: Driveline Module Mounting Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the two side bolts (1) at driveline module (3).

Fig 9: Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Lower driveline module enough gain to access to the electrical connector and bracket.
Remove the routing bracket bolt.
Remove breather hose from ECC.
Unplug the electrical connector (1).

Fig 10: Rear Axle Remove And Install
Courtesy of CHRYSLER GROUP, LLC
Lower the driveline module (1).
Disengage axle shaft (2).
Remove nut and washer halfshaft from right rear hub.
Remove halfshaft from rear hub. If hard to remove, or sticking, use a punch and hammer to tap out.