Section 8 (Right Rear Half Shaft): Installation: Installation

Fig 1: Rear Axle Remove And Install

Courtesy of CHRYSLER GROUP, LLC

1. Lift driveline module (1) with a transmission jack while installing halfshaft (2).
2. Install halfshaft washer and nut on left rear hub and tighten to 244 N.m (180 ft.lbs.).
   Fig 2: Electrical Connector

   Courtesy of CHRYSLER GROUP, LLC
3. Connect the electrical connector (1).
4. Connect the breather hose to ECC.
5. Install wire harness bracket and two mounting bolt and tighten to 10 N.m (89 in. lbs.).
   Fig 3: Rear Axle Remove And Install

   Courtesy of CHRYSLER GROUP, LLC
6. Lift driveline module (1) into place.
   Fig 4: Driveline Module Mounting Bolts

   Courtesy of CHRYSLER GROUP, LLC
7. Install the two driveline module side mounting bolts (1) and tighten to 102 N.m (75 ft.lbs.).
   Fig 5: Rear Bolt At Axle

   Courtesy of CHRYSLER GROUP, LLC
8. Install the one rear driveline module mounting bolt (1) and tighten to 102 N.m (75 ft. lbs.).
   Fig 6: Right Stay Bar

   Courtesy of CHRYSLER GROUP, LLC
9. Install the right side stay bracket and bolts (1) and tighten to 61 N.m (45 ft. lbs.).
   Fig 7: Left Side Stay Bar

   Courtesy of CHRYSLER GROUP, LLC
10. Install the left side stay bracket bolts (1) and tighten to 61 N.m (45 ft. lbs.).
11. Install the propeller shaft. Refer to INSTALLATION .
12. Fill the rear axle with fluid.
    Fig 8: Sway Bar

    Courtesy of CHRYSLER GROUP, LLC
13. Roll sway bar (2) (if equipped) into place.
    Fig 9: Left Side Sway Bar Nut

    Courtesy of CHRYSLER GROUP, LLC
14. Install left side sway bar nut (1) (if equipped) and tighten to 61 N.m (45 ft. lbs.).
    Fig 10: Right Sway Bar Nut

    Courtesy of CHRYSLER GROUP, LLC
15. Install right side sway bar nut (1) (if equipped) and tighten to 61 N.m (45 ft. lbs.).
16. Install the exhaust. Refer to MUFFLER, EXHAUST, INSTALLATION .
17. Install the wheels. Refer to INSTALLATION .