Compass - (MK49)
Courtesy of CHRYSLER GROUP, LLC
- Disconnect and isolate the battery negative cable.
- Raise and support the vehicle.
- Remove the front wheel and tire on the same side of the vehicle as the fog lamp being serviced. Refer to REMOVAL
.
- Remove the three screws (1) that secure the outboard side of the front wheel house splash shield (4) to the front fascia (2).
- Remove the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
- Remove the two push pin fasteners that secure the forward edge of the splash shield to the front fascia closeout panel.
- Fold the front of the splash shield rearward far enough to access the back of the front fascia.
Courtesy of CHRYSLER GROUP, LLC
- From behind the front fascia fog lamp bezel (2), disconnect the engine compartment wire harness connector from the front fog lamp bulb connector receptacle (3).
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry between the front fog lamp mounting ring (1) and the back of the front fascia fog lamp bezel as necessary to separate the four latch features (4) integral to the back of the fog lamp bezel from the slots in the mounting ring.
- Remove the front fog lamp unit from the fascia.