Compass - (MK49)
Courtesy of CHRYSLER GROUP, LLC
- From the back of the front fascia, position the front fog lamp and mounting ring (1) onto the back of the fog lamp bezel (2).
- Align the four slots in the front fog lamp mounting ring with the four latch features (4) integral to the back of the fog lamp bezel.
- Press firmly and evenly on the fog lamp mounting ring until the four latch features snap into place through the mounting ring slots.
- Reconnect the engine compartment wire harness connector to the front fog lamp bulb connector receptacle (3).
Courtesy of CHRYSLER GROUP, LLC
- Position the front of the front wheel house splash shield (4) to the front fascia (2) closeout panel and secure it with two push pin fasteners (3).
- Install the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
- Install and tighten the three screws (1) that secure the outboard side of the splash shield to the front fascia. Tighten the screws to 2 N.m (19 in. lbs.).
- Reinstall the front wheel and tire. Refer to INSTALLATION
.
- Lower the vehicle.
- Reconnect the battery negative cable.
- Confirm proper front fog lamp alignment. Refer to STANDARD PROCEDURE .