LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2016 >> Compass Sport SE, 2.0L Eng VIN A >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Antilock Brake System (Abs) (Service Information) >> Electrical >> Sensor, Wheel Speed, Front >> Installation >> Installation

Sensor, Wheel Speed, Front: Installation: Installation

CAUTION:

Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an open circuit. Be sure that cables are installed, routed, and clipped properly.

Fig 1: Front Wheel Speed Sensor Head
GC0083848Courtesy of CHRYSLER GROUP, LLC
  1. Install the wheel speed sensor head (3) into the knuckle (4). Install the mounting screw (2) and tighten it to 12 N.m (106 in. lbs.).
  2. Install the routing clip (1) securing the wheel speed sensor cable to the knuckle (4).
    Fig 2: Front Wheel Speed Sensor Mounting At Strut
    GC0083961Courtesy of CHRYSLER GROUP, LLC
  3. Position the wheel speed sensor routing bracket (2) on the brake flex hose bracket (5) and install the mounting screw (1). Tighten the mounting screw to 18 N.m (13 ft. lbs.).
    Fig 3: Front Wheel Speed Sensor Mounting To Body
    GC0082346Courtesy of CHRYSLER GROUP, LLC
  4. Position the wheel speed sensor cable routing clamp (4) on the outside frame rail (6) and install the mounting screw (3). Tighten the mounting screw to 18 N.m (13 ft. lbs.).
  5. Install the speed sensor cable routing clip (2) on the outside frame rail (6).
  6. Insert the wheel speed sensor cable through the hole in the body (7) and install the grommet (1) in the hole.
    Fig 4: Front Wheel Speed Sensor Wiring Connector
    GC0098433Courtesy of CHRYSLER GROUP, LLC
  7. Lower the vehicle.
  8. Connect the wheel speed sensor cable connector (2) to the wiring harness connector (3) on top of the frame rail (1).
  9. Perform the Diagnostic Verification Test and clear any faults. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals