Sensor, Wheel Speed, Rear: Installation: Front-Wheel-Drive

Fig 1: FWD Rear Wheel Speed Sensor At Hub And Bearing

Courtesy of CHRYSLER GROUP, LLC

Install the wheel speed sensor head (3) into the rear of the hub and bearing (2).
Install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 N.m (89 in. lbs.).

Fig 2: Rear Wheel Speed Sensor Mounting To Trailing Link
Courtesy of CHRYSLER GROUP, LLC
Position the wheel speed sensor (3) on the trailing link (2) and install the screw (4) securing it in place. Tighten the mounting screw to 18 N.m (13 ft. lbs.).
Position the wheel speed sensor (3) and install the routing clip (1) fastening the sensor to the trailing link (2).

Fig 3: Sensor Mounting To Rear Crossmember
Courtesy of CHRYSLER GROUP, LLC
Position the wheel speed sensor cable routing clamp (3) on the rear suspension crossmember (4) and install the mounting screw (1). Tighten the mounting screw to 18 N.m (13 ft. lbs.).

Fig 4: Rear WSS Mounting To Body
Courtesy of CHRYSLER GROUP, LLC
Install the speed sensor cable routing clip (3) on the outside frame rail (4).
NOTE:
When inserting the wheel speed sensor cable through the hole in the body, route the cable toward the shock tower to make it easier to grasp the cable to connect it to the body wiring harness connector in a later step.
Insert the wheel speed sensor cable (5) through the hole in the body (1) and install the grommet (2) in the hole.

Fig 5: Tire And Wheel Mounting
Courtesy of CHRYSLER GROUP, LLC
Install the tire and wheel assembly (1). Refer to INSTALLATION . Install and tighten the wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
Lower the vehicle.

Fig 6: Rear WSS At Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Through the opening in the bottom of the quarter trim panel, connect the wheel speed sensor cable connector (2) at the body wiring harness connector (3).
Install the cargo floor cover.
Perform the Diagnostic Verification Test and clear any faults. Refer to STANDARD PROCEDURE .