LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2016 >> Compass Sport SE, 2.0L Eng VIN A >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation/Telecommunication (Service Information) >> Antenna, Navigation >> Installation >> Installation

Antenna, Navigation: Installation: Installation

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Refer to WARNING . Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Fig 1: Navigation Antenna
GC0130866Courtesy of CHRYSLER GROUP, LLC

In vehicles equipped with the optional satellite radio system, the navigation antenna is serviced as a unit with the combination antenna located on the roof panel. Refer to INSTALLATION .

  1. Position the Global Positioning System (GPS) antenna to the instrument panel base trim.
  2. Reinstall the two plastic push-in fasteners that secure the GPS antenna to the instrument panel base trim.
  3. Reinstall the Radio Receiver Module (RRM) (also known as the radio or the head unit) into the instrument panel. Refer to RADIO, INSTALLATION .
  4. Reinstall the center bezel onto the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
  5. Reconnect the negative cable to the battery.