Driver Seat

Fig 1: Driver Seat Back Bolts

Courtesy of CHRYSLER GROUP, LLC

Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, WARNING .
WARNING:
Discard and replace the seat back bolts (1) with new bolts when servicing. Installing used bolts may result in the loosening of the seat back bolts after repair. Failure to follow these instructions may result in serious or fatal injury.
Install the seat back assembly (2) and install the new bolts (1).
Tighten the bolts to 40 N.m (30 ft. lbs.).

Fig 2: Outer Shield Tabs
Courtesy of CHRYSLER GROUP, LLC
Position the side shields onto the seat adjuster tabs (1) and seat the clip (2) fully.

Fig 3: Outer Shield Screw
Courtesy of CHRYSLER GROUP, LLC
Install the outer side shield screw (2).

Fig 4: Recliner Handle Clip
Courtesy of CHRYSLER GROUP, LLC
Install the clip (2) onto the recliner handle, if necessary.

Fig 5: Recliner Handle
Courtesy of CHRYSLER GROUP, LLC
Position the recliner handle (1) onto the spined shaft (2) and seat fully.

Fig 6: Lift Lever & Screws
Courtesy of CHRYSLER GROUP, LLC
Install the height adjuster handle (1) and install the screws (2), if equipped.

Fig 7: Lift Lever Trim Cap
Courtesy of CHRYSLER GROUP, LLC
Position the lift lever trim cap (2) and seat fully.

Fig 8: Drivers Inner Shield
Courtesy of CHRYSLER GROUP, LLC
Position the inner side shields (2) and seat fully.
Install the seat cushion. Refer to COVER, SEAT CUSHION, FRONT, INSTALLATION .