Glass Preparation - Installing A Previously Installed Quarter Glass

Fig 1: Windshield Adhesive Preparation

Courtesy of CHRYSLER GROUP, LLC

1 - WINDSHIELD

2 - SCRAPER

3 - OLD ADHESIVE

1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to STATIONARY GLASS, WARNING .
2. Level old bead of quarter glass adhesive (3) to a thickness of approximately 1 mm (0.04 in.) and remove loose adhesive.
   Fig 2: Windshield Primer

   Courtesy of CHRYSLER GROUP, LLC

   1 - PRIMER

   2 - WINDSHIELD SEAL

   NOTE:

   Typical primer installation shown in illustration.

3. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
4. Using a flash light, verify that glass primer is without damage.
5. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
6. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.).
7. Allow primer to air dry for at least 10 minutes.
8. Using a flash light, verify that glass primer is without damage.