Body - Interior & Exterior: Sunroof: Sunroof: Installation: Installation
- Install the trough guides. Refer to TUBE, SUNROOF DRAIN, INSTALLATION .
- Install the drive motor. Refer to MOTOR, SUNROOF, INSTALLATION
.
- Install the sunshade. Refer to SUNSHADE, SUNROOF, INSTALLATION .
- Install the glass panel. Refer to GLASS, SUNROOF, INSTALLATION .
Courtesy of CHRYSLER GROUP, LLC
- Raise rear end of sunroof module assembly (1) and guide into position and start the six fasteners (3).
- Visually line up the alignment guide holes (2) with the guide holes in the roof of the vehicle.
- Tighten the six fasteners (3) to 9 N.m (80 in. lbs.).
- Tighten the two side bracket fasteners (6) to 9 N.m (80 in. lbs.).
Courtesy of CHRYSLER GROUP, LLC
- Connect the drain tubes (2) to the assembly (1).
Courtesy of CHRYSLER GROUP, LLC
- Connect the electrical connector.
Courtesy of CHRYSLER GROUP, LLC
- Connect battery negative cable (4).
- Test sunroof operation, adjust glass as necessary. Refer to GLASS, SUNROOF, ADJUSTMENTS .
- Partially install the headliner and connect the sunroof wiring electrical connectors. Refer to HEADLINER, INSTALLATION .
- Temporarily install sunroof switch and perform the sunroof motor teach procedure. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE
.
- Complete headliner installation. Refer to HEADLINER, INSTALLATION .
- Verify correct sunroof operation.